Which version of MCC's InstaCal software are you using? If InstaCal is open when default settingsĪre restored, click the Refresh Boards toolbar button to reflect the changes. If you release the button before the two LEDs blink, the settings are not affected and the device starts up normally.
When you release the button, the device starts up with network settings restored to the factory default values. Press and hold the factory reset button for at least four seconds until both the Power and Activity LEDs blink.
Afterwards, restore the factory default network settings. If you connect only the PS-5V1AEPS external power adapter that ships with the E-DIO24, does the top LED stay 'ON'?Ĭonnect an ethernet cable from the Windows host system to the E-DIO24 unit. Apply power to the scanner, and connect the scanner. After your computer has re-started, run the InstaCal program by clicking Start > All Programs > Measurement Computing > InstaCal.
INSTACAL R6003 DRIVER
Configure The USB Interface Driver (InstaCal) a. If InstaCal works OK with your USB-1408FS, then you would need to. Start > All Programs > Measurement Computing > InstaCal 4. MATLAB does require that the DAQ device be listed in InstaCal, as InstaCal creates a text configuration file for the hardware. Hello you using a new E-DIO24, a previously used unit or one with an unknown history? While DAQami does not use InstaCal’s configuration file, DAQami uses our CBW64.DLL, which is the same DLL that MATLAB’s DAQ Toolbox calls into.
0 kommentar(er)
